Below you can download jbl tune 500bt bluetooth windows 10 driver for Windows.
File name: jbl-tune500bt-bluetooth_win10.exe
Version: 3.887
File size: 44386 MB
Upload source: other website
Antivirus software passed: Norton v 4.6
Jbl Tune 500Bt Bluetooth Driver Windows 10(click above to download)
Device Specification:
- Device Name: JBL Tune 500BT Bluetooth Headphones
- Compatibility: Windows 10 and other Bluetooth-enabled devices
- Connectivity: Bluetooth 4.1
- Built-in Microphone: Yes
- Battery: Rechargeable Lithium-ion battery
- Battery Life: Up to 16 hours
- Charging Time: Approximately 2 hours
- Driver Size: 32mm
- Frequency Response: 20Hz – 20kHz
- Impedance: 32 ohms
- Weight: 155g
- Colors Available: Black, Blue, Pink, White
Troubleshooting Questions and Answers:
1. Q: The headphones are not connecting to my Windows 10 device. What can I do?
A: Make sure Bluetooth is enabled on your Windows 10 device. Then, on your JBL Tune 500BT headphones, press and hold the power button for 5 seconds until the LED light starts flashing blue. This puts the headphones into pairing mode. Now, go to your Windows 10 device's Bluetooth settings, search for available devices, and select "JBL Tune 500BT" to connect.
2. Q: I can't hear any sound from my JBL Tune 500BT headphones. What should I check?
A: First, ensure that the headphones are fully charged. If the battery is low, recharge the headphones and try again. Additionally, make sure the volume on both the headphones and your Windows 10 device is turned up. Also, check if any audio settings on your device are set to mute or if the playback device is correctly selected as "JBL Tune 500BT" in the sound settings.
3. Q: The microphone on my JBL Tune 500BT headphones is not working during calls. What can I try?
A: Verify that the headphones are properly paired and connected to your Windows 10 device. Make sure the microphone is not muted or blocked by pressing the volume up button on the headphones to increase the microphone volume. Additionally, check the sound settings on your device and ensure that the correct microphone input device is selected as "JBL Tune 500BT". If the issue persists, try disconnecting and reconnecting the headphones or restart both the headphones and your Windows 10 device.
Note: These troubleshooting steps are general recommendations and may vary slightly depending on the specific software version and settings of your Windows 10 device.