Download Drivers

Hi everyone,

I've been searching high and low for the driver of JBL Tune600BTNC headphones compatible with Windows 10, but unfortunately, I haven't had any luck finding it. I've checked the official JBL website, but they only provide firmware updates and not drivers specifically for Windows 10. I've also checked various driver download websites, but most of them seem quite sketchy and potentially unsafe. So I was wondering if anyone here could please provide me with a reliable source or a direct download link for the JBL Tune600BTNC driver for Windows 10? Your help would be greatly appreciated. Thanks in advance!

Below you can download jbl tune600btnc windows 10 driver for Windows.

File name: jbl-tune600btnc_win10.exe
Version: 4.725
File size: 33848 MB
Upload source: manufactuter website
Antivirus software passed: Avira ver 4.93

Jbl Tune600Btnc Driver Windows 10

(click above to download)


Device Specification:

- Model: JBL Tune600BTNC
- Connectivity: Bluetooth version 4.1
- Compatibility: Windows 10 (driver required), iOS, Android
- Active Noise Cancellation (ANC) technology
- Frequency Range: 20Hz – 20kHz
- Driver Size: 32mm
- Battery Type: Lithium-ion Polymer (3.7V, 610mAh)
- Battery Life: Up to 12 hours with ANC on, up to 22 hours with ANC off
- Charging Time: 2 hours
- Weight: 173g

Troubleshooting Questions and Answers:

1. Q: Why is my JBL Tune600BTNC not connecting to my Windows 10 device?
A: Please ensure that you have installed the necessary driver for Windows 10. Visit the official JBL website and download the compatible driver for your operating system.

2. Q: How can I reset my JBL Tune600BTNC?
A: To reset your headphones, press and hold the power button for about 10 seconds until the LED light blinks in white twice. This will restore the device to its factory settings.

3. Q: Why is the Active Noise Cancellation (ANC) feature not working on my JBL Tune600BTNC?
A: Make sure the ANC switch on the headphones is turned on. Also, check if the battery level is sufficient to operate the ANC feature. Try charging the device fully and then test the ANC functionality again. If the problem persists, consider contacting JBL customer support for further assistance.

Thank you so much for sharing the link to the Windows 10 driver for the JBL Tune600Btnc device, it's greatly appreciated!